Skip to main content
Skip table of contents

Call Sources

Call sources are uses in conjunction with your CAD system and EMS Loop. The call sources that are in the EMS Loop system can only be updated through your CAD system. If you add call sources in your CAD System they need to be synchronized to EMS Loop using the EMS Loop Configuration utility.

Viewing Call Sources

To the current call sources that are within your EMS Loop system can be viewed in the Administration area of the EMS loop website. You can access the list by navigating to Administration

and then select Call Sources on the menu on the left side of the page.

Call Sources Grid

The Call Sources grid allows you to explore the call sources that exist in your EMS Loop system.

The grid allows sorting in ascending and descending order by simply clicking on the column header. Filtering can also be applied by clicking on the filter icon in the column header.

Adding Call Sources

Call sources must be added via your CAD system. Once you have added a new call source to your CAD system, you’ll need to synchronize that new call source to EMS Loop via the EMS Loop Configuration Utility installed at your site.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.